Checkline TI-44N Bedienungsanleitung

1TABLE OF CONTENTS01.0 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0202.0 Precautions . . . . . . . . . . . .

6.2 Setup Of Gauge When Acoustic Velocity Is UnknownIn applications where the type of material is not known or the material type is not listed in the

ELECTROMATIC E Q U I P M E N T C O., I N C.600 Oakland Ave., Cedarhurst, NY 11516–U.S.A.TEL: 516-295-4300 • FAX: 516-295-4399 CHECK•LINE®INSTRUMENTSC

1.0 INTRODUCTIONThe CHECK•LINE® TI-44N Thickness Gauge measures the wall thickness of metals,glass, ceramics and many rigid plastics. This gauge use

Mode SelectorBack LightOn/OffProbe ZeroTest Plate forZero AdjustmentEquivalent to 0.197"(5.00 mm) steelOn/Off SwitchHard-wired cable and probeLC

3.3. Complete Kit3.4 Battery Compartment3.5 LCD DisplayUnits of MeasureSelector SwitchGaugeCoupling FluidOperating InstructionsProbe/Cable AssemblyBat

4.0 GETTING STARTED4.1 Setting Units Of MeasureRemove the Battery Cover on the back side of the gaugeby pressing it down with your thumb and slidin

4.3 Turning The Power ONTurn on the power by pressing the POW key. The current acoustic velocity setting will be momentarily displayed prior to ente

5.0 QUICK START INSTRUCTIONS - STEEL THICKNESSThese Quick Start procedures are intended for those applications where the thicknessof steel is to be

6.0 SETUP FOR MEASURING THICKNESS OF MATERIALSOTHER THAN STEELThe TI-44N Thickness Gauge is supplied from the factory set for an acoustic velocity of

6.1 Acoustic Velocity Selection Table ACOUSTIC VELOCITY SELECTION TABLEMaterial Acoustic Equivalent Equivalent Type Velocity Value Value Of (mete