Checkline TT02 Bedienungsanleitung PDF herunterladen (Seite 5)

Series TT02 Digital Torque Tool Testers User’s Guide

3 SETUP

Caution!

Do not use Series TT02 torque testers with pneumatic or impact tools.

3.1 Using manual torque tools

Use a bit adapter of appropriate size and place the tool into the receptacle, as shown in Fig. 1 below.

Gradually exert torque by hand until the desired status is achieved (ex. click, slip, etc.).

Fig. 1

Typical manual torque tool test

3.2 Using motorized torque tools

It is highly recommended to use a rundown fixture when testing motorized torque tools, as shown in the

illustrations below. Use a bit adapter of appropriate size and place the tool into the rundown fixture, as

shown in Fig. 2. Activate the tool until the desired status is achieved (ex. click, slip, etc.). For best

performance, the Digital Filter should be configured to its lowest possible setting. Refer to the Digital

Filters section for details.

Fig. 2 Fig. 3 Fig. 4

Proper use of a rundown fixture with AC1026-1 rundown fixture, AC1026-2 rundown fixture,

a motorized torque tool. Note the axial for 0-50 lbFin [0-5.6 Nm] for 50-100 lbFin [5.6-11.3 Nm]

vertical alignment.

1 2 3 4 5 6 7 8 9 10 ... 27 28

Keine Kommentare

Checkline TT02 Bedienungsanleitung Seite 5