Checkline TI-MINIMAX Bedienungsanleitung PDF herunterladen (Seite 9)

MINI-MAX Ultrasonic Bolt Tension Monitor

Chapter 3 Quick Start Guide

3.1 Overview

This section demonstrates the basic procedures for setting up and measuring

bolts using the MINI-MAX. More in depth explanations pertaining to the

individual functions and features can be found in the chapters that follow.

Here we go!

3.2 Getting the MINI-MAX ready

Making all the connections

In order to get the MINI-MAX ready for operation; the following connections

must be made:

1) Remove the MINI-MAX from the carrying case.

2) Connect the transducer cable to the transducer, and plug the lemo

connector into the gauge.

3) If a temperature sensor is being used, connect the sensor to the MINI-

MAX.

3.3 Setting up the MINI-MAX

Please Read: In this section the MINI-MAX will be setup in its simplest form.

Remember this is only a quick start guide to get the user up and measuring bolts.

Before we setup the gauge to measure basic elongation, the following

assumptions must be made: A preset material type will be used. The user will

not be re-measuring the fasteners at a later date to monitor relaxation of the joint

over time. This eliminates the need for a transducer zero. All these assumptions

will be answered and explained in detail in the chapters that follow.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 180 181

Keine Kommentare

Checkline TI-MINIMAX Bedienungsanleitung Seite 9