Checkline TS2P Bedienungsanleitung

CHECK•LINE® BY ELECTROMATIC Tension Sensors TS2 SeriesOperating Manual TS2PTS2TS2B TS2HTS2L

– 9 –WARNING: When threading the process material through the rollers, follow the material path symbol on the front of the sensor. If a force is appli

–10 –4.2 GAIN AdjustmentRequirement: ZERO adjustment carried out. 1. Thread the process material through the measuring and guide rollers, followin

– 11 –5.0 SPECIFICATIONS 5.1 General SpecificationsCalibration According to factory procedureAccuracy For 10% to 100% of range: ± 1% Full Scale

– 12 –6.0 MAINTENANCE AND SERVICEThe tension meter is easy to maintain. Depending on operating time and load, the instrument should be checked accord

7.0 WARRANTYELECTROMATIC Equipment Co., Inc. (ELECTROMATIC) warrants to the original purchaser that this product is of merchantable quality and conr

ELECTROMATIC E Q U I P M E N T C O., I N C.600 Oakland Ave., Cedarhurst, NY 11516 – USA TEL: 516-295-4300 • FAX: 516-295-4399CHECK•LINE®INSTRU

– 1 – TABLE OF CONTENTS1.0 Introduction ... 02 1.

– 2 –1.0 INTRODUCTIONThe TS2 Series of universal tension sensor accurately measure the running tension of wires, cables, yarns, bers and similar pro

– 3 –2.0 AVAILABLE MODELS2.1 TS2 ModelsModel TensionRanges [g]*Measuring Head Width [mm]**Factory Calibration MaterialTS2-50 0 - 50 64 PA: 0.12 mm

– 4 –2.2 TS2P Models2.3 TS2H ModelsTS2P Guide Rollers ModelTensionRanges [g]*Measuring Head Width [mm]**FactoryCalibration MaterialTS2P-50 0 - 50

– 5 – ModelTensionRanges [g]*Measuring Head Width [mm]**FactoryCalibration MaterialTS2L-50 0 - 50 150 PA: 0.12 mm ØTS2L-100 0 - 100 150 PA: 0.12 mm Ø

– 6 –3.0 OPERATING PROCEDURES3.1 Mounting ArrangementsTS2 Series sensors can be mounted in different ways: • Mounting by using the frontplate on a

– 7 –3.3 OptionsCode DC Analog output 0 - 10 V DC Code MA Analog output 4 - 20 mA3.4 Initial Setup• Install the sensor at the desired measuring

– 8 –4.0 INTERNAL ADJUSTMENT OF THE SENSORSIf the sensor has been delivered with a display unit, the ZERO and GAIN adjustments should only be carried